HEAT SEAL APPLICATION
SOFT RUBBER PATCHES
Recommended heat press settings, requires bottom heat press. Time and temperatures may vary. Testing application is recommended. Samples are available.
Printer Friendly Version
Top and Bottom Heat
Note: Pre-heat garments for 2-3 seconds. Cotton garments may require up to 8 sec pre-heat.
1/8” Silicone Pad
Soft Rubber requires bottom heat for heat seal application.
FOR USE ON:
Cotton, Cotton/Poly Blends, 100% Polyester, Fleece and Wool
DOES NOT WORK ON:
Leather, some Nylon, some types of Coatings on Athletic Mesh and Safety Gear
Common Troubleshooting Instructions
The patch isn’t sticking.
1.) Try letting it cool a bit more. If the patch is still hot when you’re testing adhesion, it could come of before it has time to cool enough to hold tight. Please wait at least 10 minutes for the patch to cool. This allows
it to set before you test adhesion.
2.) Check your heat and pressure settings. Are they in line with the recommended temperatures for the fabric type you’re using? Some sporty polyesters, such as baseball uniforms, have a very high temperature setting needed
to get the heat seal to properly adhere.
3.) Pro tip: Try preheating your fabric for a few seconds before adding the patch. Sometimes, this can make all the difference in the world.
The patch/fabric is discoloring and burning.
1.) Use a back heat press. We always recommend using a back heat press, where the heat is only on the bottom and behind the patch. That way, it's closer to the heat seal, and won't hurt your emblem.
2.) Check your cover sheet! Barriers such as teflon or silicon can make a big difference. Have you tried using a silicon pad between the heat source and your patch? This can protect from burning.
3.) Experiment with application times. You could be keeping a patch under a press for too long. Try reducing the time and see how the application fares. Please reach out if you need similar product samples, we’d be happy to
send you some for free that you could test to get the timing down perfect.