HEAT SEAL APPLICATION
DECOFLEX PATCHES
Recommended heat press settings. Heat Seal backing is not available on faux leather patches. Time and
temperatures may vary. Testing application is recommended. Samples are available.
Printer Friendly Version
Top Heat Only
COVER SHEET:
1/8” Silicone Pad
Note: Pre-heat garments 20 seconds
Bottom Heat
COVER SHEET:
1/8” Silicone Pad
Note: Pre-heat garments 5 seconds
FOR USE ON:
Cotton, Cotton/Poly Blends, 100% Polyester, Fleece and Wool
DOES NOT WORK ON:
Leather, some Nylon, some types of Coatings on Athletic Mesh and Safety Gear
Common Troubleshooting Instructions
The patch isn’t sticking.
1.) Try letting it cool a bit more. If the patch is still hot when you’re testing
adhesion, it could come of before it has time to cool enough to hold tight. Please wait at least 10
minutes for the patch to cool. This allows it to set before you test adhesion.
2.) Check your heat and pressure settings. Are they in line with the recommended
temperatures for the fabric type you’re using? Some sporty polyesters, such as baseball uniforms,
have a very high temperature setting needed to get the heat seal to properly adhere.
3.) Pro tip: Try preheating your fabric for a few seconds before adding the patch.
Sometimes, this can make all the difference in the world.
The patch/fabric is discoloring and burning
1.) Use a back heat press. We always recommend using a back heat press, where the heat
is only on the bottom and behind the patch. That way, it's closer to the heat seal, and won't
hurt your emblem.
2.) Check your cover sheet! Barriers such as teflon or silicon can make a big
difference. Have you tried using a silicon pad between the heat source and your patch? This can protect
from burning.
3.) Experiment with application times. You could be keeping a patch under a press for
too long. Try reducing the time and see how the application fares. Please reach out if you need similar
product samples, we’d be happy to send you some for free that you could test to get the timing
down perfect.